b.If your are installing a media card reader, connect the USB cable to the USB system board connector labeled MEDIA.
Figure
8.If installing a new drive, connect the opposite end of the data cable to the appropriate system board connector.
NOTE: If you are installing a new SATA optical drive, connect the data cable for the first optical drive to the white SATA connector on the system board labeled SATA2. Connect the data cable for a second optical drive to the black SATA connector on the system board labeled ESATA. If the ESATA connector is already populated, connect the second optical drive to the light blue connector (8200 Elite models) or the white connector (6200 Pro models) labeled SATA1.
Refer to System Board Connections on page 128 for an illustration of the system board drive connectors.
9.Replace the front bezel and computer access panel.
10.Reconnect the power cord and any external devices, then turn on the computer.
11.Lock any security devices that were disengaged when the access panel was removed.
Removing a Hard Drive from a Drive Bay
NOTE: Before you remove the old hard drive, be sure to back up the data from the old hard drive so that you can transfer the data to the new hard drive.
1.Prepare the computer for disassembly (Preparation for Disassembly on page 125)
2.Remove the access panel (Computer Access Panel on page 126)
3.Disconnect the power cable and data cable from the back of the hard drive.
144 Chapter 7 Removal and Replacement Procedures – Microtower (MT) Chassis