Release Notes for 07.8.04

 

 

Software Fixes

 

 

 

 

 

Bug ID

Bug Description

Protocol/

Version

Version

 

 

Feature

Found

Fixed

 

 

 

 

 

54622

On an EP 8 Port Mini-GBIC Redundant

ACL

 

07.8.02

 

Management module, a port in a virtual router

 

 

 

 

interface on which an ACL is applied was changed,

 

 

 

 

added, or removed and the ACL was re-applied.

 

 

 

 

This behavior may result in a system reload.

 

 

 

 

 

 

 

 

54724

Installing an EP 48-Port 10/1000-TX RJ45 module

ACL

 

07.8.02

 

in one slot can result in a packet loss on interfaces

 

 

 

 

on a module in a different slot, on which outbound

 

 

 

 

ACLs are configured. When an outbound ACL is

 

 

 

 

configured, CAM entries are incorrectly aged out.

 

 

 

 

 

 

 

 

55354

On an EP 8 Port Mini-GBIC Redundant

BGP

 

07.8.02

 

Management module, starting in release 07.8.02,

 

 

 

 

BGP route selection is based on administrative cost

 

 

 

 

rather than selecting a local route with a lower

 

 

 

 

precedence over a BGP-advertised route from a

 

 

 

 

peer device (as in earlier releases).

 

 

 

 

 

 

 

 

55572

On an EP 8 Port Mini-GBIC Redundant

Spanning Tree

 

07.8.02

 

Management module, several topology changes

 

 

 

 

caused the system to reload. This resulted in

 

 

 

 

accessing an invalid VLAN index.

 

 

 

 

 

 

 

 

55689

When you enter the ip access-group 0 in

ACL

 

07.8.02

 

command, all configured ACL entries are removed

 

 

 

 

from physical and virtual routing interfaces.

 

 

 

 

 

 

 

 

55772

The routing switch performed a system reload

System

 

07.8.02

 

triggered by the watchdog timer when a large

 

 

 

 

number of CAM entries were aged out.

 

 

 

 

 

 

 

 

55773

A system reload occurs when an ACL is modified to

ACL

 

07.8.02

 

re-assign traffic to a different priority queue.

 

 

 

 

 

 

 

 

56078

Valid values for Virtual Router Redundancy Protocol

VRRPE

 

07.8.02

 

Extended (VRRPE) slow-start are 1-255, but the

 

 

 

 

values 0 to 65535 can be entered.

 

 

 

 

 

 

 

 

56079

When ACL clauses are configured with the IP

ACL

 

07.8.02

 

address 0.0.0.0 and with varying masks, the mask

 

 

 

 

is not checked when you delete the clauses.

 

 

 

 

 

 

 

 

56080

ACLs configured with clauses containing DSCP

ACL

 

07.8.02

 

mapping or priority mapping do not match the

 

 

 

 

DSCP map or priority mapping field. As a result, if

 

 

 

 

there are multiple clauses, packets are matched

 

 

 

 

incorrectly.

 

 

 

 

 

 

 

 

56083

If you delete an EP 8 Port Mini-GBIC Redundant

System

 

07.8.02

 

Management module and then re-insert the module

 

 

 

 

back into the device after the aggregated-vlan

 

 

 

 

command and the default maximum transmission

 

 

 

 

unit (MTU) value are configured, the MTU changes

 

 

 

 

back to the default value after the insertion.

 

 

 

 

 

 

 

 

39