Software Fixes

 

 

Release Notes for 07.8.04

 

 

 

 

 

 

 

 

Bug ID

 

Bug Description

Protocol/

Version

Version

 

 

 

 

Feature

Found

Fixed

 

 

 

 

 

 

 

 

75878

 

Module: N/A

SSH

 

07.8.03d

 

 

 

Symptom:

 

 

 

 

 

 

In a Switch or Router if the SSH is used for

 

 

 

 

 

 

management, occasionally this can cause a system

 

 

 

 

 

 

reset.

 

 

 

 

 

 

Resolution: Fixed in this release.

 

 

 

 

 

 

 

 

 

 

 

76577

 

Module: N/A

UDLD

 

07.8.03d

 

 

 

Symptom: In a Switch or Router configured with

 

 

 

 

 

 

UDLD and Holddown Threshold, if the UDLD

 

 

 

 

 

 

configured interface is disabled due to reaching the

 

 

 

 

 

 

threshold, the UDLD KeepAlive packets continue to

 

 

 

 

 

 

be sent out causing the remote end to falsely keep

 

 

 

 

 

 

the UDLD interface active.

 

 

 

 

 

 

Resolution: Fixed in this release.

 

 

 

 

 

 

 

 

 

 

 

72430

 

Module: N/A

VRRP

 

07.8.03d

 

 

 

Symptom: In a Router configured with VRRP, the

 

 

 

 

 

 

ICMP PING is not responded to when the VRID on

 

 

 

 

 

 

the interface configured with the Master VRRP is

 

 

 

 

 

 

disabled.

 

 

 

 

 

 

Resolution: Fixed in this release.

 

 

 

 

 

 

 

 

 

 

 

 

 

07.8.03e

 

 

 

 

 

 

 

 

 

 

 

74759

 

Module: N/A

ACL

 

07.8.03e

 

 

 

Symptom: In a Switch or Router, when an extended

 

 

 

 

 

 

Access Control List is configured using a port range

 

 

 

 

 

 

for the Source Port and the Destination Port, the

 

 

 

 

 

 

Access Control List is incorrectly saved in the

 

 

 

 

 

 

configuration.

 

 

 

 

 

 

Resolution: Fixed in this release.

 

 

 

 

 

 

 

 

 

 

 

77627

 

Module: N/A

System

 

07.8.03e

 

 

 

Symptom: In a Switch or Router configured with a

 

 

 

 

 

 

Redundant Management Module, the configuration

 

 

 

 

 

 

file is not synchronized when executing the “Write

 

 

 

 

 

 

Memory” command. The following error message is

 

 

 

 

 

 

seen:

 

 

 

 

 

 

Sync config data in flash...Flash is in use, aborted

 

 

 

 

 

 

Resolution: Fixed in this release.

 

 

 

 

 

 

 

 

 

 

 

 

 

07.8.03f

 

 

 

 

 

 

 

 

 

 

56