SECTION 4

MAINTENANCE

Replacing the Feed Rollers

To replace the feed rollers on the AstroJet printer follow the steps below:

1.Before removing the feed roller access plate, unplug the power to the printer.

2.Using a Phillips screwdriver, remove the three screws from the feed roller access plate.

3.Remove the feed roller access plate.

4.Rotate the feed roller shaft so that the screws are face up and use a 3/32-inch Allen wrench to remove the two button head cap screws. This will permit you to remove one half of the feed roller. Rotate the shaft until the two screws holding the second half of the feed roller in place are accessible. Remove those screws also. Install the feed roller half and replace the screws. Rotate the shaft, replace the second feed roller half, and fasten with the remaining screws.

5.Replace the feed roller access plate and fasten with the four Phillips screws.

20