HP C2M97UA C2M97UA (1), (2), (3), (1), (2), (3), (1), NOTE:

NOTE: The heat sink on your system board may appear different from the heat sink shown.

1.Disconnect the following cables from the system board:

(1)Display panel cable

(2)Speaker cable

(3)Fan power connector

2.Remove the power connector bracket Phillips screw (1) and remove the power connector bracket

(2).

3.Remove the two Phillips screws (3) that secure the system board to the base enclosure.

4.Lift the left side of the system board (1) until it rests at an angle.

Component replacement procedures 67