
4.If it is necessary to replace the wireless antenna cables and transceivers:
a.Release the wireless antenna cables from the clips (1) built into the display enclosure.
b.Release the wireless antenna transceivers (2) from the display enclosure. (The wireless antenna transceivers are attached to the display enclosure with
c.Remove the wireless antenna cables and transceivers.
Reverse this procedure to reassemble and install the display assembly.
Power connector
Description | Spare part number |
|
|
Power connector |
|
|
|
IMPORTANT: Make special note of each screw and screw lock size and location during removal and replacement.
Before removing the power connector, follow these steps:
1.Shut down the computer.
2.Disconnect all external devices connected to the computer.
3.Disconnect the power from the computer by first unplugging the power cord from the AC outlet and then unplugging the AC adapter from the computer.
4.Remove the battery (see Battery on page 42).
5.Remove the keyboard (see Keyboard on page 47).
6.Remove the top cover (see Top cover on page 51).
7.Remove the hard drive (see Hard drive on page 56).
8.Remove the USB board (see USB board/Audio jack on page 59).
9.Remove the WLAN (see WLAN module on page 60).
Component replacement procedures | 87 |