Chapter 11

If this did not solve the issue, try the next solution.

Solution 3: Clean the rollers

Solution: Clean the rollers.

Make sure you have the following materials available:

•A lint-free cloth, or any soft material that will not come apart or leave fibers.

•Distilled, filtered, or bottled water (tap water might contain contaminants that can damage the print cartridges).

To clean the rollers

1.Turn off the product and remove the power cord.

2.Remove the rear door to access the rollers.

Troubleshooting

3.Dip the lint-free cloth into the purified or distilled water, and squeeze any excess water from it.

4.Clean the rubber rollers to remove any dust or dirt buildup.

5.Replace the rear door. Gently push the door forward until it snaps into place.

6.Plug the power cord back in, and turn on the product.

7.Try to print again.

Cause: The rollers were dirty and needed to be cleaned.

If this did not solve the issue, try the next solution.

Solution 4: Contact HP support for service

Solution: If you have completed all of the steps provided in the previous solutions and are still having a problem, contact HP support for service.

Go to: www.hp.com/support.

If prompted, choose your country/region, and then click Contact HP for information on calling for technical support.

Cause: You might need assistance to enable the product or software to function properly.

104 Troubleshooting