CAUTION: After removing an expansion card, you must replace it with a new card or expansion slot cover for proper cooling of internal components during operation.
12.To install a new expansion card, slide the card under the slot cover retention latch and press the card down into the socket on the system board.
Figure 2-17 Installing an Expansion Card
NOTE: When installing an expansion card, press firmly on the card so that the whole connector seats properly in the expansion card slot.
13.Rotate the slot cover retention latch back in place to secure the expansion card.
14.Connect external cables to the installed card, if needed. Connect internal cables to the system board, if needed.
15.Replace the access panel.
16.If the computer was on a stand, replace the stand.
17.Reconnect the power cord and turn on the computer.
18.Lock any security devices that were disengaged when the access panel was removed.
19.Reconfigure the computer, if necessary. Refer to the Computer Setup (F10) Utility Guide for instructions on using Computer Setup.
ENWW | Removing or Installing an Expansion Card 25 |
