
POST Error Messages
POST Error Messages (Continued)Screen Message | Probable Cause | Recommended Action |
|
|
|
Configuration incorrect. | Run Computer Setup (F10 Setup) and | |
Not Set | RTC | check configuration of Onboard |
| battery may need to be | Devices. |
| replaced. | Set the date and time under Control |
|
| Panel or in F10 Setup depending on |
|
| the operating system. |
|
| If the problem persists, replace the RTC |
|
| battery. |
|
|
|
Invalid time or date in | Set the date and time under Control | |
Set | configuration memory. | Panel or in F10 Setup depending on |
| RTC | the operating system. |
| battery may need to be | If the problem persists, replace the RTC |
| replaced. | battery. |
|
|
|
| CMOS jumper may not | Check for proper placement of the |
| be properly installed. | CMOS jumper, if applicable. |
|
|
|
Memory amount has | Press the F1 key to save the memory | |
| changed since the last | changes. |
| boot (memory added or |
|
| removed). |
|
|
|
|
| Memory configuration is | Run Computer Setup (F10 Setup). |
| incorrect. | Make sure memory module(s) (if any) are |
|
| installed properly. |
|
| If third party memory has been added, |
|
| test using |
|
| Verify proper memory module type. |
|
|
|
RAM failure. | Run Computer Setup (F10 Setup) or | |
|
| Windows utilities. |
|
| Ensure memory and continuity modules |
|
| are installed correctly. |
|
| Verify proper memory module type. |
|
| Remove and replace the identified faulty |
|
| memory module(s). |
|
| If the error persists after replacing |
|
| memory modules, replace the system |
|
| board. |
|
|
|
Memory modules do not | Replace memory modules with matched | |
Mismatch | match each other. | sets. |
|
|
|
Service Reference Guide, dc7600 |