HP dc7700 7.9Vertically Oriented Expansion Card, 7.9.1Expansion Card Retainer

Removal and Replacement Procedures— Small Form Factor (SFF) Chassis

✎

✎

The computer automatically recognizes the additional memory when the computer is turned on.

To reassemble the computer, reverse the removal procedure.

If you normally lock the Smart Cover Lock, use Computer Setup to relock the lock and enable the Smart Cover Sensor.

7.9Vertically Oriented Expansion Card

7.9.1Expansion Card Retainer

1.If you have locked the Smart Cover Lock, restart the computer and enter Computer Setup to unlock the lock.

2.Turn off the computer properly through the operating system, then turn off any external devices.

3.Disconnect the power cord from the power outlet and disconnect any external devices.

4.Remove the computer cover (Section 7.5).

5.Release the slot cover retention latch that secures the PCI slot covers by lifting the green tab on the latch and rotating the latch to the full open position 1.

6.Remove the single screw that keeps the card retainer in place 2 and slide the retainer to the left to remove it from the chassis 3.

To install the card retainer, reverse the removal procedure.

Service Reference Guide, dc7700 433612-001 7–13