Removal and Replacement Procedures - Convertible Minitower (CMT) Chassis

10.Slide the bracket on the end of the expansion card down into the slot on the back of the chassis and press the card down firmly into the socket on the system board.

✎When you install an expansion card, make sure you press firmly on the card so that the whole connector seats properly in the expansion card socket on the system board.

11.Close the expansion slot latch, making sure that it snaps firmly into place.

12.Connect external cables to the installed card and internal cables to the system board as needed.

13.Replace the computer access panel.

14.If you normally lock the Smart Cover Lock, use Computer Setup to relock the lock and enable the Smart Cover Sensor.

15.Reconfigure the computer, if necessary. Refer to the Computer Setup (F10) Utility Guide on the Documentation and Diagnostics CD for instructions about using Computer Setup.

 

Service Reference Guide, dc7700

433612-001

6–15