HP dv2000 dv2000 manual Removing the Audio/Infrared Board

Removal and Replacement Procedures

2.Release the ZIF connector to which the audio/infrared board cable is connected and disconnect the cable 1 from the system board.

3.Remove the two Phillips PM2.5×5.0 screws 2 that secure the audio/infrared board to the computer.

4.Lift the rear edge of the audio/infrared board 3 and swing it forward until the audio connectors disengage from the base enclosure.

5.Remove the audio/infrared board 4.

Removing the Audio/Infrared Board

Reverse the above procedure to install the audio/infrared board.

Maintenance and Service Guide 5–59