HP DV2500 manual Display inverter

12. Remove the camera module (2) from the bracket.

Reverse this procedure to install the camera module.

Display inverter

If it has been determined that the display inverter is the component that must be replaced to complete the computer repair, the display assembly does not have to be removed. Follow the procedures in this section to replace the display inverter. For information on replacing the display assembly and other display assembly internal components, see Display assembly on page 59.

Description	Spare part number
Display inverter (includes 2-sided tape)	417097-001

Before removing the display inverter, follow these steps:

1. Shut down the computer. If you are unsure whether the computer is off or in Hibernation, turn the computer on, and then shut it down through the operating system.

2. Disconnect all external devices connected to the computer.

3. Disconnect the power from the computer by first unplugging the power cord from the AC outlet and then unplugging the AC adapter from the computer.

4. Remove the battery (see Battery on page 40).

Remove the display inverter:

1. Turn the computer display-side up, with the front toward you.

2. Open the computer as far as it will open.

3. Remove the two rubber screw covers (1) on the display bezel bottom edge. The display rubber screw covers are included in the Rubber Feet Kit, spare part number 417095-001.

Component replacement procedures 43