HP DV2500 manual

9. If it is necessary to replace the display bezel or any of the display assembly internal components, remove the following screw covers and screws:

(1)Four rubber screw covers on the display bezel top edge. The display rubber screw covers are included in the Rubber Feet Kit, spare part number 417095-001.

(2)Two rubber screw covers on the display bezel bottom edge

(3)Four Phillips PM2.5×5.0 screws on the display bezel top edge

(4)Two Phillips PM2.5×9.0 screws on the display bezel bottom edge

10. Flex the inside edges of the left and right sides (1) and the top and bottom sides (2) of the display bezel until the bezel disengages from the display enclosure.

11. Remove the display bezel (3). Display bezels are available using the following spare part numbers:

●448607-001 (for use only with computer models equipped with a camera module)

●448606-001 (or use only with computer models not equipped with a camera module)

NOTE: See Camera module on page 41 for camera module replacement instructions. See Display inverter on page 43 for display inverter replacement instructions.

Component replacement procedures 61