6
Hardware Replacement Procedures
This section includes:
|
Tape Drive and Fibre Channel to SCSI Router Replacement
These procedures can be done for any tape drive that is connected to the Fibre Channel to SCSI router. For information about what tape drives can be connected to a Fibre Channel to SCSI router, see Supported Storage Devices on page
Tape Drive Replacement
1.Perform a forced reset on the tape drive in SCF by entering in the following command:
SCF> RESET TAPE1, FORCED
2.Power off the tape drive by pressing the power switch. For the location, see Figure
Figure
Power Switch
M8201R Fibre Channel to SCSI Router Installation and User’s