Hardware Replacement Procedures

Fibre Channel to SCSI Router Replacement

3.Unplug the power cord from the AC power outlet, and then unplug the other end from the tape drive’s AC power receptacle.

4.Disconnect the SCSI cable from port 1 by unscrewing the screws by hand. Do not use a screwdriver.

5.Disconnect the differential terminator from port 2 by unscrewing the screws by hand. Do not use a screwdriver.

6.Place the old tape drive aside.

7.Connect the new tape drive. Refer to section 3 Installing the Fibre Channel to SCSI Router for the NonStop NS-Series Server when installing a new tape drive.

8.Power cycle the Fibre Channel to SCSI router by powering it off and then on.

9.Start the tape drive in SCF by entering in the following command:

SCF> START TAPE $TAPE1

Fibre Channel to SCSI Router Replacement

1.Perform a forced reset on the tape drive in SCF by entering in the following command:

SCF> RESET TAPE1, FORCED

2.Power off the tape drive by pressing the power switch. See Figure 6-1 for the location.

3.Power off the Fibre Channel to SCSI router.

4.Unplug the power cord from the AC power outlet, and then unplug the other end from the AC power receptacle on the Fibre Channel to SCSI router.

5.Disconnect the fiber cable from the small form-factor pluggable (SFP) on the unit.

Figure 6-2. Rear View of the Fibre Channel to SCSI Router

Power

 

Port 0

AC Power Switch

Small Form-Factor

Port 1

Receptacle

Pluggable (SFP)

 

 

 

 

6.Disconnect the SCSI cable from the Fibre Channel to SCSI router on port 0. If there is another tape drive connected to port 1, disconnect that device also.

M8201R Fibre Channel to SCSI Router Installation and User’s Guide—529971-005

6-2