Use the HP sp400 Series Configuration Software

Network tab

The Network tab allows you to configure the All-in-One so it can gain access to a wireless network.

IP Address

The IP Address section is where you make choices about how the All-in-One will connect wirelessly.

•Enable DHCP check box: Select this box to enable the Dynamic Host Configuration Protocol (DHCP). A DHCP server on your network is required to use this option. Contact your network administrator to determine if your Wi-Fi network has a DHCP server.

•DHCP Time Out (seconds): The number of seconds the All-in-One will spend attempting to locate a DHCP server.

The following fields are enabled only if the Enable DHCP check box is not selected. Contact your network administrator for the correct values.

•Static IP

•Subnet Mask

•Default Gateway

•Primary DNS

•Secondary DNS

Wireless Network Type

•Access Point: Select Access Point if the All-in-One will communicate with the server through an access point.

•Ad Hoc: Select Ad Hoc if the All-in-One will communicate with the server application directly (not through an access point).

14