Download software and connect the All-in-One

3Download software and connect the All-in- One

Download software

IMPORTANT: Do not connect an All-in-One device to your computer with a USB cable before installing the HP sp400 Series Configuration Software. If this does happen, cancel the Found New Hardware Wizard.

1.Download the HP sp400 Series Configuration Software and save it in a location you will remember or select the default location.

The software is available at www.hp.com/support/handheldsp400aio.

NOTE: If you select the default location when you download the software, the HP sp400 Series

Configuration Software will be downloaded and saved in the following location: C:\Program Files\Hewlett-Packard\HP sp400 Series Configuration Software. The All-in-One drivers will also be downloaded and saved in this location, inside an FTDI folder.

2.Run the hp_sp400_Configuration_EN.exe file.

3.For best results, select all of the defaults in the Installation Wizard.

Connect the All-in-One

1.If you have not already done so, download the HP sp400 Series Configuration Software by following the instructions in “Download software.”

2.Turn on the All-in-One device by pressing the green Power button.

3.Use a USB-compliant cable with a type B 5-pin plug to connect the All-in-One to a USB port on your computer.

6