Use the HP sp400 Series Configuration Software

4Use the HP sp400 Series Configuration Software

Make sure the All-in-One has been connected successfully and open the HP sp400 Series Configuration Software.

The connection status of the device is displayed in the top-left corner of the window. If the device status reads “Not connected,” make sure you followed the instructions for connecting the All-in-One in “Connect the All-in-One” or refer to “Troubleshoot problems.”

If the All-in-One is not connected, some buttons will be disabled.

The Software

The HP sp400 Series Configuration Software is composed of the following seven tabs:

•General

•Timeouts & Limits

•Network

•Server

•Imager

•Update

•User Feedback

When a tab is selected, the software will attempt to read values from the All-in-One device. The following six buttons appear at the bottom of each tab:

•The Clear Page button clears the values on the tab. After clicking the Clear Page button, click the Read from Device button to see the current values.

•The Defaults button replaces the values on the tab with the default values. The Write to Device button must be pressed to save the default values on the device.

•The Write to File button allows the user to save the values on a tab to an HHP file. This button is only available when the Network tab is selected.

•The Read from Device button refreshes all values on that tab so they reflect the current configuration of the All-in-One device.

•The Write to Device button saves to the All-in-One device any edits you have made on that tab. The Write to Device button is never enabled on the General tab.

9