4.Replace the water controller ("Replacing the water controller" on page 59).

Condensation pump

The condensation pump is a component of the water group located at the bottom of the MCS G2 unit.

The following tools are required for installation:

•T-25 Torx driver

Removing the condensation pump

1.Disconnect the power ("Disconnecting the power" on page 23).

2.Remove the water controller ("Removing the water controller" on page 57).

3.Remove the bottom fan unit ("Removing the bottom fan unit" on page 29).

4.Remove the water group cover.

a.Using a T-25 Torx driver, remove the two flathead T-25 Torx screws that secure the condensation pump.

Removal and replacement procedures 30