4.Press and hold the C key to reset the management module.
5.Reconnect the power cables ("Reconnecting the power" on page 73).
6.Verify the
7.Complete the operation checklist (on page 73).
Operator display
The operator display is located on the front door of the MCS G2 unit.
The following tools are required for installation:
•
•Wire cutters
Removing the operator display
1.Disconnect the power ("Disconnecting the power" on page 23).
2.Open the front door of the MCS G2 unit.
3.Using wire cutters, clip the cable ties that bind all the cables on the front of the MCS G2 unit.
Removal and replacement procedures 49