Flow meter sensor
The flow meter sensor is a component of the water group located at the bottom of the MCS G2 unit.
The following tools are required for installation:
•
•Flathead screwdriver
Removing the flow meter sensor
1.Disconnect the power ("Disconnecting the power" on page 23).
2.Turn off the water ("Turning off the water" on page 24).
3.Drain the main outlet water hose ("Draining water from the MCS G2 unit" on page 24).
4.Remove the water controller ("Removing the water controller" on page 57).
5.Remove the bottom fan unit ("Removing the bottom fan unit" on page 29).
6.Remove the water group cover.
a.Using a
Removal and replacement procedures 38