Using the On-Screen Display Menu
■Management—Allows you to control vertical and horizontal keystoning, view the cumulative lamp hours, or set the OSD horizontal and vertical position, timeout, and transparency.
✎By default, the OSD menu is on top of the displayed image. Selecting OSD Transparency from the Management menu allows you to adjust this setting so the displayed image can be seen behind the OSD menu. Changes can be seen as they are being made.
■A/V & HDTV Control—Allows you to stretch the format to fill the screen or to use the original aspect ratio and fill the screen, using HDTV (High Definition Television) format. Refer to the “HDTV Modes” section of Chapter 6 for more information. Also allows color space selection, audio preference selection, and Gamma adjustment.
■Input Source Select—Allows you to select which source to display. If the selected source is not available, the original source will be displayed again. You may also cycle through available sources by pressing the Source button on the remote control.
■Factory Reset—Resets all previously saved user settings to the original factory settings.
Special On-Screen Messages
Special on-screen messages will appear on the projection display to identify the following conditions:
■No Source Found. Please Check Signal Cable—Indicates the video cable may not be plugged into the projector or the selected video input is not accurate.
■Input Signal Out of Range. Please Change Display Mode—Indicates the projector is unable to access the appropriate input signal.
■Going to Standby—Indicates the projector is entering a sleep mode or is powering off the lamp.
Compaq iPAQ Microportable Projector MP3800 User’s Guide | 3–9 |