Setup Menus

emulated by the Wyse WY-50/50+/60 terminals. Refer to the Wyse Emulations chapter for details.

The TVI 950 and TVI 955 emulations provide compatibility with software designed to drive the TeleVideo 950 and 955 terminals, respectively.

The Unisys T27 emulation provides compatibility with software designed to drive the Unisys T27 terminal. Refer to the Unisys T27 Emulation chapter for details.

The Viewdata 40, Viewdata 80 and Viewdata Split modes enable access to a viewdata service using one of three display formats, as described in the Viewdata Mode section in the Getting Started chapter.

The VT PCTerm emulation provides compatibility with software designed for the PC Term mode supported by DEC. This is the same as the VT510 emulation except that keyboard scan codes are sent on key press/release instead of ASCII codes by default.

The VT52 and VT100 emulations enable you to run applications written for the DEC VT52 and VT100 terminals, respectively. Refer to the DEC VT Emulations chapter for details.

The VT500 7-Bitand VT500 8-Bitemulations enable you to run applications written for the DEC VT320 terminal, the difference is in their treatment of 8-bit control codes. When VT500 7-Bitis selected, all 8-bit codes are converted to their 7-bit equivalents, whereas VT500 8-Bitleaves 8-bit codes unchanged. If you are using VT200 applications, select VT500 7-Bit. Refer to the DEC VT Emulations chapter for details.

The VT+HP220 emulation is based on the VT500 terminal series and includes the HP function keys F1 - F8 (not user programmable). The terminal ID is set to VT220.

The VT100+ emulation is an enhanced version of the VT100 emulation that provides additional functionality such as colours. It is the same as the VT-UTF8 emulation except that it only supports ASCII characters 0-127 (decimal).

The VT-UTF8emulation is an enhanced version of the VT100 emulation that supports non-English and drawing characters. It supports localization of the single- byte and double-byte character sets and all other languages supported by Windows. Additional functionality, such as colours, is also provided.

The WY50, WY50+ and WY60 emulations provide compatibility with software designed to drive the Wyse WY-50, WY-50+ and WY-60 terminals, respectively. Refer to the Wyse Emulations chapter for information on these emulations.

The WYSE PCTerm emulation provides compatibility with software designed for the PC Term personality supported by Wyse. Keyboard scan codes are sent on key press/ release instead of ASCII codes by default.

Graphics Emulation

Factory default: ReGIS

This option is only available if this version of TeemTalk supports graphics emulations and the Alpha Emulation option is set to one of the DEC VT, Ansi BBS, AIXTerm,

6-28