HP NX6120 manual Removing the System Board Screws and Screw Locks

Removal and Replacement Procedures

2.Turn the notebook upside down with the rear panel toward you.

3.Disconnect the fan cable from the system board through the memory module compartment.

4.Disconnect the serial connector cable 1 and the Bluetooth cable 2 from the system board.

5.Remove the T8M2.0×4.0 screw 3 that secures the system board to the base enclosure next to the RJ-11 connector.

✎Step 6 applies only to full-featured models.

6.Remove the 2 HM5.0×9.0 screw locks on each side of the parallel connector 4.

7.Remove the 2 HM5.0×9.0 screw locks on each side of the external monitor connectors 5.

Removing the System Board Screws and Screw Locks

Maintenance and Service Guide 5–53