Removal and Replacement Procedures

8.Use the optical drive connector to lift the system board up 1 until the power connector 2 is clear of the base enclosure.

9.Slide the system board to the left 3 at an angle and remove it.

Removing the System Board

10.If necessary, disconnect the RJ-11 connector module cable from the system board and remove the RJ-11 connector module and cable.

Removing the RJ-11 Connector Module and Cable

Reverse the above procedures to install the system board.

5–54

Maintenance and Service Guide

Page 138
Image 138
HP NX6120 manual Reverse the above procedures to install the system board