Network Interface Board Installation

The standard interface for the RJ-6000 Series printer has a parallel Centronics compatible interface as standard equipment. The network interface board, RJ- ETH13TX, for connection to EtherNet is also available as an option.

The following procedure explains how to install the network interface board.

CAUTION

•The power to the RJ-6000 Series must be switched off and the power cord removed before the network interface board is installed.

Step 1

Undo the screws holding the silver colored interface plate on the left side of the board box below the printer and remove the interface plate.

Interface Plate

Board Box

Step 2

Insert the optional interface board into the slot as shown in the diagram. When the interface board has reached the back, push it again to ensure it is pushed fully back.

Interface Board

80

RJ-6000 Series USER GUIDE Functions Edition