HP Rlve 810 G2 manual Wlan module

WLAN module

Description	Spare part number
Intel Dual Band Wireless-AC 7260 802.11 ac (2x2) WiFi + BT 4.0 combo	710663-001
Intel Dual Band Wireless-N 7260AN 802.11 a/b/g/n (2x2) WiFi + BT 4.0 combo	717379-001
Intel Dual Band Wireless-N 7260NB 802.11 a/b/g/n (2x2) WiFi	717380-001
Intel Dual Band Wireless-N 7260AN 802.11 a/b/g/n (2x2) WiFi + BT 4.0 combo (for use in	747833-001
Indonesia)

CAUTION: To prevent an unresponsive system, replace the wireless module only with a wireless module authorized for use in the computer by the governmental agency that regulates wireless devices in your country or region. If you replace the module and then receive a warning message, remove the module to restore device functionality, and then contact technical support.

Before removing the WLAN module, follow these steps:

1.Turn off the computer. If you are unsure whether the computer is off or in Hibernation, turn the computer on, and then shut it down through the operating system.

2.Disconnect the power from the computer by unplugging the power cord from the computer.

3.Disconnect all external devices from the computer.

4.Remove the battery (see Battery on page 28).

5.Remove the service door (see Service door on page 30).

Remove the WLAN module:

1.Disconnect the WLAN connector from the computer.

2.Disconnect the WLAN antenna cables (1) from the terminals on the WLAN module.

NOTE: The WLAN antenna cable labeled MAIN connects to the WLAN module “Main” terminal. The WLAN antenna cable labeled AUX connects to the WLAN module “Aux” terminal.

3.Remove the Phillips M2.0×2.5 screw (2) that secures the WLAN module to the system board. (The WLAN module tilts up.)

34 Chapter 5 Removal and replacement procedures for Customer Self-Repair parts