5.Install the DIMM. Refer to the installation sheet for server-specific configuration and population guidelines.

6.Replace the access panel ("Access panel" on page 11).

Expansion board options

Depending on the model, HP ProLiant 100 Series servers use one of the following methods to retain expansion boards within the server:

A single expansion board retainer for all expansion boards (internal)

Individual retainers for each expansion board

A single expansion board retainer for all expansion boards (external)

This document provides the following procedures for installing expansion boards into HP ProLiant 100 Series servers:

Installing an expansion board with a single retainer

Installing an expansion board with individual retainers

Installing an expansion board with an external retainer

For server-specific expansion board installation instructions, refer to the installation sheet that ships with the server.

Installing an expansion board with a single retainer

CAUTION: To prevent damage to the server or expansion boards, power down the server and remove all AC power cords before removing or installing the expansion boards.

To install the component:

1.Power down the server (on page 6).

2.Extend the server from the rack, if applicable.

3.Remove the access panel ("Access panel" on page 11).

Hardware options installation 42

Page 42
Image 42
HP Security Camera ML100 manual Expansion board options, Installing an expansion board with a single retainer