6.Release the media bay retainers and slide the half-height media device part of the way into the bay.

7.Connect the four-pin power cable to the half-height drive.

8.Connect the device cable to the device and the system board or to an expansion board, as directed by the option documentation.

9.Slide the media drive fully into the bay until it is seated securely.

10.Close the media bay retainers.

Installing a full-height media device

NOTE: This process only represents one installation method. For specific instructions for installing the media device into the server, refer to the installation sheet for your specific server.

1.Power down the server (on page 6).

2.Extend the server from the rack, if applicable.

3.Remove the access panel ("Access panel" on page 11).

4.Access the removable media cage.

5.Remove the bezel blank.

NOTE: HP recommends that you remove all bezel blanks to facilitate drive installation.

Hardware options installation 39