Self‐Test | HP T1000J, T1000 G3, T1500 G3, T750J, T750 G2, T1500J

OPERATION

the Self‐Test

NOTE: The batteries must be fully charged and the UPS must not be in Battery mode to perform the self‐test.

Press and hold the (Test/Alarm Reset) button for three seconds to initiate the self‐test. During the five-second test, the bar graph indicators cycle through twice. If the UPS beeps or a UPS alarm indicator stays on, see “Troubleshooting” on page 27.

12	HP T750 G2, HP T750J, HP T1000 G3, HP T1000J, HP T1500 G3, and HP T1500J UPS Models User Guide S 505922-002

Image 19

HP T1000J, T1000 G3, T1500 G3, T750J, T750 G2, T1500J manual Self‐Test

Contents

Part Number 505922-002 July 2009 Second Edition Audience assumptions Page Regulatory compliance identification numbers Compliance notices Discharge Japanese notice Battery replacement notice Grounding methods to prevent electrostatic discharge Contents Shows the HP T750 G2 UPS 1Introduction Introduction Important Safety Instructions Safety Warnings UPS Internal Battery 3InstallationEquipment Removing the Battery Cover Replace the metal battery cover Replace the UPS front bezel UPS If the UPS beeps or a UPS alarm indicator stays on, see on This section shows the UPS rear panels Rear Panels HP T750 G2, 230V Rear Panel HP T1500 G3, 230V Rear Panel 4Operation UPS on BatteryUPS On Mode UPS OffFront Panel Self‐Test Configuration Additional UPS Features Options DIP Switch Settings Serial Port Serial Port Pin Assignment HP Power Manager Power Manager SoftwareTransient Protector Battery Care UPS Maintenance UPS and Batteries Disconnecting the Internal Battery Connector Spares Battery Spares Batteries Removing the Battery Cover New Batteries Used Battery or UPS Model List 7Specifications Electrical Output Battery Alarms and UPS Conditions 8Troubleshooting Troubleshooting Guide You Contact HP Support Contact Information Battery Warranty Warranty InfromationWarranty Computer Load Protection Guarantee