HP T1000 G3, T1000J, T1500 G3, T1500J, T750 G2, T750J Grounding methods to prevent electrostatic discharge

Grounding methods to prevent electrostatic discharge

Several methods are used for grounding. Use one or more of the following methods when handling or installing electrostatic-sensitive parts:

SUse a wrist strap connected by a ground cord to a grounded workstation or computer chassis. Wrist straps are flexible straps with a minimum of 1 megohm +10 percent resistance in the ground cords. To provide proper ground, wear the strap snug against the skin.

SUse heel straps, toe straps, or boot straps at standing workstations. Wear the straps on both feet when standing on conductive floors or dissipating floor mats.

SUse conductive field service tools.

SUse a portable field service kit with a folding static-dissipating work mat.

If you do not have any of the suggested equipment for proper grounding, have an authorized reseller install the part.

For more information on static electricity or assistance with product installation, contact an authorized reseller.

Contents

Page Audience assumptions ÊSpecial Symbols RISK OF ELECTRIC SHOCK CAUTION: REFER TO OPERATOR'S MANUAL RJ-45 RECEPTACLE ÊRegulatory compliance notices ÊElectrostatic discharge Grounding methods to prevent electrostatic discharge ÊTable of Contents ÊChapter Introduction The HP T750 G2, HP T750J, HP T1000 G3, HP T1000J, HP T1500 G3, and Figure 1 shows the HP T750 G2 UPS STwo standard communication options (USB and serial port) SBacked by worldwide agency approvals Safety Warnings IMPORTANT SAFETY INSTRUCTIONS SAVE THESE INSTRUCTIONS D A N G E R W A R N I N G ÊInspecting the Equipment ÊConnecting the UPS Internal Battery Slide up and remove the metal battery cover (see Remove the protective label from the internal battery connector (see 5Connect the red wire to the positive ()) battery connector (see Figure 5) 6Replace the metal battery cover 7Replace the UPS front bezel ÊInstalling the UPS ÊUPS Rear Panels Page Page ÊTurning the UPS On ÊStarting the UPS on Battery ÊTurning the UPS Off ÊStandby Mode ÊUPS Front Panel ÊInitiating the Self‐Test Additional UPS Features ÊVoltage Configuration ÊCommunication Options ÊUSB Port ÊSerial Port ÊNetwork Transient Protector ÊHP Power Manager Software UPS Maintenance ÊUPS and Battery Care ÊTransporting the UPS ÊStoring the UPS and Batteries ÊUPS Battery Spares ÊOrdering Spares ÊUPS Spare Parts List ÊReplacing Batteries 3Disconnect the red battery cable 4Pull the battery out onto a flat, stable surface 5Carefully disconnect the black battery cable to the UPS ÊTesting New Batteries ÊRecycling the Used Battery or UPS Specifications Page Page Troubleshooting ÊAudible Alarms and UPS Conditions ÊSilencing an Audible Alarm ÊSite Wiring Fault (100–120VModels Only) Page ÊTechnical Support ÊBefore You Contact HP ÊHP Contact Information ÊLimited Warranty Ê$250,000 Computer Load Protection Guarantee ÊPre-FailureBattery Warranty

HP Grounding methods to prevent electrostatic discharge

Models: T1000 G3 T1000J T1500 G3 T1500J T750 G2 T750J