ADDITIONAL UPS FEATURES
ÊNetwork Transient Protector
The network transient protector, shown in Figure 17, is located on the rear panel and has jacks labeled IN and OUT. This feature accommodates a single RJ‐45 (10BaseT) network connector.
Low voltage models can also accommodate an RJ‐11 telephone connector that provides protection for modems, fax machines, or other telecommunications equipment. As with most modem equipment, it is not advisable to use this jack in digital PBX (Private Branch Exchange) environments.
NOTE: DO NOT connect any telephone or fax/modem equipment
1Connect the input connector of the equipment you are protecting to the jack labeled IN.
2Connect the network or telephone (low voltage models only) cable to the jack labeled OUT.
OUTIN
OUT
IN
Figure 17 Network Transient Protector
ÊHP Power Manager Software
HP Power Manager software ensures maximum power reliability of computer systems through comprehensive control of UPSs. The
NOTE: To install and configure the software, see the software user guide. The software user guide is available for download from the HP website
(http://www.hp.com/go/rackandpower).
HP Power Manager:SDoes not require complex management systems, which simplifies deployment, configuration, and management of
SShuts down and reboots any UPS and attached load devices based on a
SCustomizes alert generation with modifiable dialog boxes, command execution, and email and broadcast messages.
SMonitors the status of the UPS and reports alarms.SDisplays a power log for analysis.16 | HP T750 G2, HP T750J, HP T1000 G3, HP T1000J, HP T1500 G3, and HP T1500J UPS Models User Guide S |