HP V3651AU, V3523TU, V3930TU, V3931TU, V3929TU Before removing the camera module, follow these steps

Description	Spare part number
Camera module (includes camera module bracket and 2-sided tape)	453673-001

Before removing the camera module, follow these steps:

1. Shut down the computer. If you are unsure whether the computer is off or in Hibernation, turn the computer on, and then shut it down through the operating system.

2. Disconnect all external devices connected to the computer.

3. Disconnect the power from the computer by first unplugging the power cord from the AC outlet and then unplugging the AC adapter from the computer.

4. Remove the battery (see Battery on page 53).

Remove the camera module:

1. Turn the computer display-side up, with the front toward you.

2. Open the computer as far as it will open.

3. Remove the four rubber screw covers (1) on the display bezel top edge. The display rubber screw covers are included in the Rubber Feet Kit, spare part number 417096-001.

4. Remove the four Phillips PM2.5×7.0 screws (2) that secure the display bezel top edge to the display assembly.

5. Flex the inside edges of the left and right sides (1) and the top edge (2) of the display bezel until the bezel disengages from the display enclosure.

78 Chapter 4 Removal and replacement procedures