Installation and Setup

To connect control equipment

■9-pin serial cable

■2.5-mm (3/32-in) to 3.5-mm (1/8-in) stereo mini-phone cable

■3.5 × 1.3-mm DC power cable

In some installations, the projector might not be visible to the remote control, such as for rear projection. Use one of these solutions to enable the remote control to work:

■Use a remote control extension. Plug its cable into the remote connector on the projector. Install the receiver in the room with the presenter.

■Wire the remote control to the projector. Construct a cable with a 2.5-mm (3/32-in) stereo mini-phone jack at one end and a 3.5-mm (1/8-in) stereo mini-phone jack at the other end. Plug the small connector into the remote control and the large connector into the remote connector on the projector.

Reference Guide

33