set for the projector—contact the network administrator for a valid TCP/IP network configuration, then set up the projector accordingly.
If you forget the projector’s web administrator password:❏Reset the projector's network configuration to the factory-default values. To do this, turn off the projector. Then insert a straightened paperclip into the small hole in the connectivity module panel. While pressing the small button inside, turn the main disconnect switch off and on and continue holding the button for at least 15 seconds.
If you can access the projector via the web, but only the home page:❏The web interface has been protected by the web administrator. Contact the administrator.
If the network configuration is completely wrong and you cannot fix it:❏Reset the projector's network configuration to the factory-default values. To do this, turn off the projector. Then insert a straightened paperclip into the small hole in the connectivity module panel. While pressing the small button inside, turn the main disconnect switch off and on and continue holding the button for at least 15 seconds.