HTC PDA PHONE II, Andes service manual Connector, Back up battery replacement, Pad

6.4 Connector, Back up battery replacement.

If you are authorized by HTC for component replacement, you could do below replacement with following notice:

Soldering	Back up battery replacement.
	In case of back up battery defective, and
pad
	need to be replaced, please be noticed to
	soldering requirement:
	1. Soldering Spec must be within 350 °C
	/ 5 seconds.
	2. Never touch the two pin in short
	circuit ,release one by one.
	Warranty Seal (Security Label)
	Be sure to apply new Warranty seal once
	the unit has been repaired before sending
	back to customer.
	P/N: 77H00083-00

In case of MB replacement, since the IMEI has to follow new MB IMEI, repair site is required to re-print Regulatory label to change IMEI no, but Serial No. should remain unchanged.

Put the Battery into its place and lock it.

HTC confidential

© 2001, HTC Corporation. All rights reserved. TOTAL 77 CONT.ON. 31 PAGE NO. 30