HTC Z4619BF, Z4824, Z5426BF, Z4220BF, Z4219 Gauge Wheels, maintenance, Important Information

maintenance

Gauge Wheels

Anti-scalp rollers are properly adjusted when they are just slightly off of the ground when the deck is at the desired cutting height in the operating position. Anti- scalp rollers then keep the deck in the proper position to help prevent scalping in most terrain conditions.

IMPORTANT INFORMATION

Adjust Anti-scalp rollers with the mower on a flat level surface.

The gauge wheels can be set in three positions:

•Upper position 1½ to 3" (38 to 76 mm) grass.

•Middle position 3" to 4½" (76 to 114 mm) grass.

•Lower position 4½" to 6" (114 to 152 mm) grass.

The rollers should be approximately ¼" (6.5 mm) from ground. Do not adjust the rollers to support the deck.

1.Adjust the deck to the desired cutting height (see

“TO ADJUST DECK CUTTING HEIGHT” in the operation section of this manual).

2.Using a ¾" wrench and a 9/16" wrench, remove the nut and shoulder bolt from the gauge wheel.

3.Lower the gauge wheel to the ground, and raise it up to the next highest hole.

4.Replace and tighten the nut and shoulder bolt.

5.All of the gauge wheels should be adjusted to the same position.

6.Readjust the gauge wheels if the cutting height is changed.

CZ-9

Anti-scalp roller

English-48