Humminbird Control Head Base Assembly, Figure, Tilt and Swivel Mount

Control Head Installation

Assembling the Control Head Base

Your control head base will either have a tilt mount or a tilt and swivel mount. Refer to procedures A or B below to assemble and mount the control head base.

A. If you have a tilt mount, follow these steps:

1.Set the tilt mount control head base in place on the mounting surface. Mark the four mounting screw locations with a pencil or punch.

2.Set the base aside, and drill the four mounting screw holes using a 9/64" bit.

3.Proceed to Routing the Control Head Cables Under the Deck.

Tilt and Swivel Mount

Control Head Base Assembly

Mount Arms

B. If you have a tilt and swivel mount, follow these steps:

1.Insert the mount arms into the base. Then, hold the mount arms in place as you turn the base upside down.

Base

Swivel

Ring

Countersink

Side Out

Arm Screws, 4 #6 x7/16"

Figure 5

2.Insert the swivel ring into the base, with the countersink holes for the arm screws facing out.

3.Secure the mount arms with the 4 #6 screws provided (Figure 5). Hand tighten only!

4.Set the assembled control head base in place on the mounting surface. Mark the four mounting screw locations with a pencil or punch.

5.Set the base aside, and drill the four mounting screw holes using a 9/64" bit.

6.Proceed to Routing the Control Head Cables Under the Deck.

4