Humminbird Inserting the Pivot Bolt, Figure, Figure, Figure, Figure, seam aligned, Leading edge, Trailing edge, to the Transom, Mounting the Assembly

Transom Transducer Installation

Inserting the Pivot Bolt

Figure 19

Mounting the Assembly

to the Transom

3.Put the pivot bolt through the assembly to hold it in position and loosely installthe nut, but do NOT tighten the nut at this time (Figure 19).

4.Align the mounting bracket transducer assembly with the drilled holes in the transom. With a 5/16" socket driver, mount the assembly to the transom using the two #10 - 1" long screws provided (Figure 20). Hand tighten only!

NOTE: Make sure that the mounting screws are snug,but do not fullytightenthe mountingscrewsat this time to allowthe transducerassemblyto slidefor adjustmentpurposes.

	5. Adjustthe initial angleof the transducerfrom
	back to front by rotating the transducer until
	the side seam on the transducer is almost
	parallel with the bottom of the boat, one click
Figure 20	at a time in either direction (Figure 21 and22).

Adjusting the Initial Transducer Angle

		One click too high
		Correctly aligned
		(transducer side
		seam aligned
		with boat bottom)
		Trailing edge
	Leading edge	One click too low
Figure 21	Figure 22

14