Control Head Installation
Attaching the Cables to the Control Head
Followthese stepsto attachthe power and transducer cables to the controlhead:
Power Temperature Transducer
Figure 8
1.Matching the cable plugs to the shape and orientation of the sockets, insert the transducer and power cables into the correct sockets on the control head (Figure 8).
2.With the control head in place, tilt and/or swivel the unit through its full range to make sure there is enough cable slack for the unit to move freely. Hand tighten the thumbknob bolt when you achieve the desired position for the control head.
You are now ready to install the transducer. See Transducer Installation Overview and then find the section that refers to your transducer type.
7