Control Head Installation

Attaching the Control Head to the Base

Follow these steps to attach the control head to the already-assembled base:

NOTE: The transducer cable and power cable should be routed prior to securing the

mounting bracket to the deck.

1.Apply marine-grade silicone sealant to the drilled holes for the mounting bracket.

2.Place the mounting bracket on the mounting surface, aligning with the drilled holes.

3.Insert the four #8 Phillips countersink wood screws into the mounting holes and hand tighten only!

Pivot Knuckle

Thumbknob Bolt

Gimbal Knob

Figure 7

Mounting Holes

4.Insert the thumbknob bolt through the pivot knuckle on the control head (Figure 7).

5.Align the pivot knuckle with the mount base arms and slide into place, twisting slightly if necessary, until the unit is firmly seated.

6.Rotate the control head to the desired angle and hand tighten the thumbknob bolt.

7.Thread the gimbal knob onto the pivot bolt and tighten.

6