Manuals / Brands / Marine Equipment / Fish Finder / Humminbird / Marine Equipment / Fish Finder

Humminbird Installation Overview, Installation Overview, •Testing the complete installation and locking the transducer position

Models: 150 160 170 180 190C

1 52

Download 52 pages, 1.07 Mb

Installation Overview

Installation Overview

Before you start installation, we encourage you to read these instructions carefully in order to get the full benefit from your PiranhaMAX™.

There are three basic installation tasks that you must perform for the PiranhaMAX™:

•Installing the control head

•Installing the transducer

•Testing the complete installation and locking the transducer position.

1

Contents

Page •PiranhaMAX™150 - Single Beam, 160 V x 128 H Monochrome Display •PiranhaMAX™160 - Dual Beam, 160 V x 128 H MonochromeDisplay •PiranhaMAX™170 - Dual Beam, 240 V x 160 H MonochromeDisplay •PiranhaMAX™180 - TriBeam, 240 V x 160 H MonochromeDisplay •PiranhaMAX™190c- Single Beam, 320 V x 240 H TransmissiveColor Display WEEE DIRECTIVE: © 2008 Humminbird®, Eufaula AL, USA. All rights reserved Page Light (Setting Not Saved in Memory) Depth Range (Setting Not Saved in Memory) Chart Speed (Setting Saved in Memory) Contrast (Setting Saved in Memory) Fish ID+™ (Setting Saved in Memory) Page Installation Overview Control Head Installation Inline Fuse Holder Control Head Base Assembly Use the following steps to route the control head cables under the deck Follow these steps to attach the control head to the already-assembledbase: mounting bracket to the deck Page Transducer Installation Overview Transom Transducer Installation If high speed operation is critical, you may want to consider using an Deadrise Angle Find a turbulence-freelocation at least 15” from the propeller(s) and not in line with trailer bunks or rollers. (Figure 11) 3rd hole you willnot do untila laterprocedure Figure Ratchets Placed in Position Figure 18a Inserting the Pivot Bolt Leveling the Mounting Assembly Horizontally NOTE: Your boat may have a pre-existingwiring channel or conduit that you can use for the transducer cable Attaching the Cables to the Control Head Routing the Cable Storing Excess Cable Your control head is now ready for operation If the unit is working properly, gradually increase the boat speed to test Fully TightenAll Three Inside the Hull Transducer Installation Page Fill the hull with enough water to submerge the transducer body. Use a Mix an ample quantity of 7.Weight the transducer so that it will not move while the epoxy is curing NOTE: When the epoxy cures, no water is necessaryinside the hull Your control head is now ready for operation Trolling Motor Transducer Installation Page Page - Structure 11- 455 kHz, Right Beam Fish Symbol (Tri Beam Unit only) Page Page PiranhaMAX™Portables Page Page Language (International only) Units (International only) Tri Beam Dual Beam Single Beam NOTE: Bottom Black View is not available on color models Page Page Page Page 8.The displaybegins to fade out. Images are not as sharp as normal Page •Damaged or has failed because of an accident or abnormal operation; PLEASE DO NOT RETURN THIS PRODUCT TO STORE FOR SERVICE NOTE: Please do not return your Humminbird® to the store for service •Include a copy of your receipt (to show proof and date of purchase) 800 ft (250 m) – (PMAX170/180/190c) 800 Watts (PTP) – (PMAX150/160) Contact Humminbird®