Humminbird Ratchets Placed in Position, Figure 18a, Rib, Bead, Beads, Rib at, Knuckle, Ratchet, Ratchet, position, Figure 18b, Figure 18c

Transom Transducer Installation

2.Place the two ratchets, one on either side of the transducer knuckle, so that the beads on each ratchet line up with the desired position number on the knuckle (Figure 18a). If you are setting the ratchets at position 1, the beads on each ratchet will line up with the rib on the transducer knuckle to form one continuous line on the assembly (Figure 18b).

NOTE: The ratchets are keyed; make sure that the square teeth on each ratchet face the square teeth on the transducer knuckle, and the triangular teeth face outward.

Hold the ratchets on the transducer knuckle with one hand and fit the mounting bracket over them until it snaps into place with the other hand. Refer to the illustration (Figure 18d).

Transducer Knuckle Positions	Ratchets Placed in Position 1
Knuckle	Beads
	Ratchet
	Rib at
	position 1
Figure 18a	Figure 18b
Ratchets Placed in Position 2	Fitting the Mounting Bracket Over the Ratchet
Bead

Rib

Ratchet

Figure 18c Figure 18d

13