Transom Transducer Installation

Adjusting the Transducer

Mounting Position

Seam aligned with boat hull

Figure 23

Leveling the Mounting

Assembly Horizontally

Level

Level

Figure 24

6.Adjust the transducer assembly vertically, until the seam on the leading edge of the transducer (the edge closest to the transom of the boat) is level and just slightly below the hull (Figure 23).

NOTE:The transducerhas a naturaldownwardslant of 4-5 degreesfromleadingedge(closestto the boat transom) to trailing edge (farthest away from the boat). Looking at the back of the transducer, the seamshouldbe slightlybelowthe bottomof the hull.

7.Continue to adjust until the bracket is also level from port to starboard (horizontaly level as you look at the transducer from behind the boat (Figure 24).

8.Mark the correct position on the transomby tracing the silhouette of the transducer mounting bracket with a pencil or marker.

9.Tighten the pivot bolt, usingthe pivot screw and nut to lock the assembly.Hand tighten only!

10.Hand-tighten the two mounting screws.

NOTE: You will drill the third mounting hole and finalize the installation after you route the cable and test and finish the installation in the following procedures.

15