Humminbird Use the following steps to route the control head cables under the deck

Control Head Installation

Routing the Control Head Cables Under the Deck

Use the following steps to route the control head cables under the deck.

NOTE: Under the deck cable routing is not always possible. If this is not an option, the cables should be routed and secured above deck.

NOTE: See the installation section for your transducer type in order to plan the location of the transducer and cable route.

Tilt Mount or Tilt and Swivel Mount Tilt Mount or Tilt and Swivel Mount: Control Head Base

1a. Mark and drill a 3/4" hole as shown in Figure 6. Route the cables through the hole. The cables will exit through the center hole on the control head base.

1b. If the cables cannot be routed directly beneath the control head base, mark and drill a 3/4" hole that will allow you to run the cables close to the control head base.

3/4” 19 mm

Figure 6

5