6

 

00598

1

1

“A”“A”

01553

2

(1) Bottom edge of mower

(2) Lift link adjustment nut (1) Unterkante des Mähwerks

(2) Hubstangen-Stellmutter

(1) Extrémités du carter de coupe

(2)Ecrou de réglage du bras de suspension arrière (1) Parte inferior de la esquina de la segadora

(2)Tuerca de ajuste del várillaje de levantamiento (1) Bordo inferiore del tagliaerba

(2)Dado di regolazione dell'articolazione di sollevamento (1) Onderkant van de maaimachine

(2)Bijstelmoer

SIDE-TO-SIDE ADJUSTMENT

Raise mower to highest position.

At the midpoint of both sides of mower, measure height from bottom edge of mower to ground. Distance “A” should be the same or within 6mm (1/4") of each other.

If adjustment is necessary, make adjustment on one side of mower only.

To raise one side of mower, tighten lift link adjustment nut on that side.

To lower one side of mower, loosen lift link adjustment nut on that side.

NOTE: Three full turns of adjustment nut will change mower height about 1/8".

Recheck measurements after adjusting.

SEITLICHE EINSTELLUNG

Das Mähwerk auf die höchste Position einstellen.

Auf beiden Seiten des Mähwerks in der Mitte den Abstand von der Unterkante des Mähwerks zum Boden messen. Der Abstand “A” sollte auf den beiden Seiten um höchstens 6 mm (1/4') voneinander abweichen.

Falls eine Einstellung notwendig sein sollte, die Einstel- lung nur auf einer Seite des Mähwerks vornehmen.

Um eine Seite des Mähwerks anzuheben, die Hubstangen- Stellmutter auf der jeweiligen Seite festziehen.

Um eine Seite des Mähwerks abzusenken, die Hubstangen -Stellmutter auf der jeweiligen Seite lösen.

HINWEIS: Drei volle Umdrehungen der Stellmutter verändern die Höhe des Mähwerks um etwa 3 mm (1/8").

Nach der Einstellung die Abstände erneut prüfen.

REGLAGE TRANSVERSAL

Relever le carter de coupe au maximum.

A partir du milieu de chaque extrémités latérales du carter de coupe, mesurer la distance du bord du carter par rapport au sol .

La distance (A) doit être la même des deux côtés à 6 mm près.

Si un réglage est nécessaire, ne l'effectuer que d'un seul côté en se référant à l'autre côté.

Abaisser ou soulever un côté du carter de coupe en ajustant la position de l'écrou de réglage de ce côté.

REMARQUE : A trois tours complets de l'écrou de réglage correspond une variation de la hauteur au-dessus du sol, du carter de coupe, de 0,3 cm.

Contrôler à nouveau la distance au sol après chaque opération de réglage.

ADJUSTE DE LADO A LADO

Levante la segadora a su posición más alta.

A media distancia de ambos lados de la segadora, mida la altura desde la parte inferior del extremo de la segadora al suelo. La distancia “A” debe ser la misma o dentro de 6mm (1/4") de la una a la otra.

Si el ajuste es necesario, haga el ajuste en un lado de la segadora solamente.

Levante un lado de la segadora por apretar la tuerca de ajuste del várillaje de levantamiento en ese lado.

Baje un lado de la segadora por desapretar la tuerca de ajuste del várillaje de levantamiento en ese lado.

NOTA: Cada tres vueltas completas de la tuerca de ajuste cambiará la altura de la segadora en aproximadamente (1/8").

Vuelva a revisar las medidas después del adjuste.

REGOLAZIONE FIANCO A FIANCO

Alzare il tagliaerba nella posizione più alta.

Sui punti centrali di entrabi i lati del tagliaerba, misurare l'altezza dal bordo inferiore del tagliaerba al suolo. La distanza “A” deve essere la stessa o diversa non più di circa 6mm (1/4 di pollice).

Se necessario, fare la regolazione su un solo lato del tagliaerba.

Per alzare un lato del tagliaerba, stringere il dado di rego- lazione dell'articolazione di sollevamento su quel lato.

Per abbassare un lato del tagliaerba, allentare il dado di regolazione dell'articolazione di sollevamento su quel lato.

NOTA: Tre giri completi del dado di regolazione cambiano l'altezza del tagliaerba di circa 3 mm (1/8 di pollice).

Dopo aver fatto la regolazione, ricontrollare le misurazi- oni.

LINKS/RECHTS BIJSTELLEN

Zet de maaimachine in de hoogste stand.

Meet vervolgens in het midden tussen beide zijkanten van de maaimachine de hoogte van de onderkant van de maaimachine tot de grond. Afstand “A” moet ofwel hetzelfde zijn, ofwel binnen 6 mm (1/4") van elkaar lig- gen.

Indien bijstellen nodig is, mag dit slechts aan één kant van de maaimachine gebeuren.

Draai de bijstelmoer vaster aan de kant van de maaima- chine die u hoger wilt instellen.

Draai de bijstelmoer looser aan de kant van de maaima- chine die u lager wilt instellen.

N.B.: Drei slagen van de bijstelmoer veranderen de hoogte ongeveer 3 mm (1/8").

Controleer na het bijstellen de hoogte opnieuw.

55

Page 55
Image 55
Husqvarna LT131 SIDE-TO-SIDE Adjustment, Seitliche Einstellung, Reglage Transversal, Adjuste DE Lado a Lado

LT131 specifications

The Husqvarna LT131 is a modern lawn tractor designed to deliver superior performance and efficiency for residential lawn care. Engineered with a focus on versatility and user comfort, this model stands out as a reliable choice for homeowners looking to maintain their lawns with ease.

One of the primary features of the LT131 is its powerful engine. Equipped with a robust, high-performance motor, it provides the necessary torque and speed to tackle various terrains and mowing conditions. This reliable engine ensures consistent cutting performance, whether you are dealing with thick grass or overgrown areas.

The LT131 incorporates an advanced cutting system, featuring a wide mower deck that allows for efficient grass cutting on extensive areas. With multiple cutting heights adjustable through a simple lever mechanism, users can customize their mowing experience to achieve the desired lawn finish. The precision cutting blades are designed to provide a clean and thorough cut, promoting healthier grass growth.

In terms of technology, the Husqvarna LT131 is equipped with user-friendly features that enhance the overall mowing experience. The ergonomic design of the driver’s seat provides ample support and comfort, ensuring that users can maneuver the tractor effortlessly over long periods. The intuitive dashboard layout displays essential information clearly, allowing operators to monitor speed and fuel levels easily.

The LT131 also features a tight turning radius, making it easier to navigate around obstacles such as trees, flowerbeds, and garden furniture. This maneuverability is complemented by the tractor's sturdy build and stability, ensuring smooth operation over uneven landscapes.

Another highlight of the Husqvarna LT131 is its maintenance-friendly design. The accessible engine and mower deck allow for easy cleaning and maintenance, facilitating a longer lifespan for the machine. Additionally, Husqvarna offers a range of compatible accessories, enabling users to equip their LT131 for various tasks such as mulching, bagging, or snow removal.

In conclusion, the Husqvarna LT131 exemplifies a perfect blend of power, efficiency, and comfort tailored for residential lawn care. Its impressive features, technological innovations, and ease of use make it an excellent investment for homeowners seeking an effective solution for lawn maintenance. This combination of performance and reliability positions the LT131 as a top choice in the lawn tractor market.