SAFETY REGULATIONS
The One-man Sawmill Safety Equipment
!WARNING!
The
There are a number of safety devices and guards in order to prevent accidents when using the sawmill. These are described in the sawmill’s general description. See page 15.
The safety devices and guards also require regular inspection and maintenance. Measures and intervals are documented in the section Maintenance. See page
Fuel Safety
!WARNING!
The fuel used in the
1.The fluid, its vapour, and its exhaust fumes are poison- ous.
2.Can cause skin irritation.
3.Is highly inflammable.
Special safety regulations apply to the fuel used with the
Personnel
The following apply to personnel using the one- man sawmill:
1.Shall have read and understood the content of this operator’s manual.
2.Must not be under the influence of alcohol or medication, nor suffering from tiredness.
3.Good lighting is required when using the sawmill outside daylight hours.
4.Shall not be a minor.
5.Earthed circuit breaker recommended.
Risk Zone
The risk zone is evident from the picture to the right.
No unauthorised persons may be present in the risk zone.
The risk zone should also be kept free of foreign objects and the ground within the risk zone should be flat so that the operator avoids stum- bling.
Safety During Use
The safety regulations that apply while using the
The operator should observe the following safety measures before and during use:
1.Check that all safety devices and guards are fitted and undamaged.
2.Check that no fuel has been spilt on the outside of the tank or on the ground.
3.Ensure that there are no people or animals within the
4.The stopping and locking devices required to fasten the log shall be used in the intended manner. See pages
5.Adjust the bandsaw guide so that it is as close to the log as possible. See page 27.
6.Adjust the scale and check that the bandsaw moves freely over the short and long log supports by the red markings on the scale. See page 22.
FIG. 1 |
6 – English
