Using this manual
Illustrations used were current at the time of printing, but subsequent production changes may cause your machine to vary slightly in detail. Excel Industries, Inc. reserves the right to redesign and change the machine as deemed neces- sary, without notification. If a change has been made to your machine which is not reflected in this parts manual, see your Hustler dealer for current information and parts.
Hardware Description Codes & Abbreviations
The following codes are used throughout this parts manual. Refer to this list when ordering parts.
ABBREVIATIONDESCRIPTION
CB | Carriage Bolt |
CE | Clevis Pin |
CP | Cotter Pin |
CS | Cap Screw |
CW | Cup Washer |
FDRW | Fender Washer |
FW | Flat Washer |
HX | Hex Head |
LW | Lock Washer |
MB | Machine Bushing |
MS | Machine Screw |
NT | Nut |
SC | Self Tapping Cap Screw |
SH | Socket Head |
SB | Shoulder Bolt |
SS | Set Screw |
OD | Outside Diameter |
ID | Inside Diameter |
|
|
Standard Torques
The following chart lists the standard torque values for the threaded fasteners found in this manual. Torque all cap screws, nuts and set screws to these values unless a different torque is shown in the Notes section next to the fastener
SIZE |
| NM | SIZE | NM | |
.250 | 8.2 | 11.1 | M3 | 1 | 1.3 |
.312 | 17 | 23 | M4 | 2.2 | 3 |
.375 | 30 | 40 | M5 | 4.5 | 6.1 |
.438 | 48 | 65 | M6 | 7.7 | 10.4 |
.500 | 73 | 99 | M8 | 18.5 | 25 |
.562 | 105 | 143 | M10 | 37 | 50 |
.625 | 145 | 200 | M12 | 64 | 87 |
.750 | 260 | 350 | M16 | 160 | 215 |
.875 | 420 | 565 | M20 | 320 | 435 |
1.00 | 625 | 850 | M24 | 555 | 750 |
NOTE:
Loctite® 592 to be used on all pipe threads.
Lubricate all grease zerks.
365262 4/07 |