|
|
|
| Honda |
| Dipstick | |||
|
|
|
|
|
|
|
|
|
|
Engine oil |
|
| ||
filler tube |
|
|
| |
|
|
|
|
|
Engine oil filter | Engine oil | |
drain plug | ||
| ||
|
|
Figure 9-16A
Dipstick & Engine oil filler tube
5
2
6
3
1
2
2
5
4
Deck Belt Drive Layout
1.Spindle drive belt
2.Deck blade spindle pulley
3.Spindle belt tension idler
4.Spindle belt tension idler spring (7.5" at operation)
5.Deck belt idler pulley
6.Idler arm
Engine oil
Engine drain plug oil filter
Briggs & Stratton
Figure 9-16B
Dipstick & Engine oil filler tube
Engine oil |
|
|
Engine | ||
drain plug |
| oil filter |
|
|
|
Kohler
Figure
sliding the chain out of the anchor bracket slot. This will relieve the tension on the deck belt idler spring. Fig.
5.Pull the idler to the left of the machine to provide maximum belt clearance.
6.Remove the existing belt and replace with a new belt.
7.Route the new belt per Fig.
8.
|
| Figure |
| Viewed from |
|
| top of unit |
|
1. | Pump belt |
|
2. | Engine pulley |
|
3. | Pump idler pulley |
|
4. | Pump idler arm |
|
5. | Pump pulley |
|
6. | Electric deck clutch |
|
7. | Pump idler spring |
|
8. | Fixed idler pulley |
|
|
| 7 |
| 5 |
|
| 4 | 5 |
|
| |
| 3 | 8 |
| 1 | 2, 6 |
|
| Figure |
9.
10.
Integrated pump/motor drive belt replacement
1.Park the unit on a flat surface. Stop the engine and remove the ignition key. Make sure deck clutch switch is in the down (OFF) position. Place control levers in the park brake position. Disconnect negative battery cable.
2.Place the deck in the lowest position.
3.The deck belt must be removed from the clutch pulley first by releasing the deck belt tension by pulling on the belt tension chain and sliding the chain out of the anchor bracket slot. This will relieve the tension on the deck belt idler spring. Fig.
365262 4/07 |
|